«

»

May 10

Cisco 5508 WLC Setup and Initial Configuration

This post details how to  do initial Cisco 5508 WLC setup and in the next post it goes into more detailed steps of configuring WLANs. Following are some pictures of the device and then we start with initial configuration and software upgrade

 

Photo 26-04-2012 14 34 49Photo 26-04-2012 14 34 56Photo 26-04-2012 14 35 13Photo 26-04-2012 14 35 28Photo 26-04-2012 14 36 07

 

 

Cisco 5508 WLC Software Upgrade and Initial Configuration

 

1. First step would be to assign IP address and setup password for GUI where more advanced configuration would be done. Power on Controller and use Console cable to connect to controller. It will guide through the basic tasks of assigning IP Address, Subnet Mask and Gateway and admin username/password. It will force you to select other options as domain, DHCP server etc which you can set at this point but can change later so enter whatever you like for these. Once IP address is assigned to the controller. You can connect your laptop, assign it an IP address from the same range and access the GUI using web browser on the IP address assigned to WLC.

2. After entering the admin username and password you will be greeted with the following page which will display the current version of software running.

First Page

3. Now, the first thing we will do is to upgrade the running software on the controller from 6.0 to 7.2. The upgrade involves upgrading the software and also Field Recovery Image which is used when you want to use the

boot menu such as restoring to backup version or other boot options. Download the latest controller software from Cisco website, setup a TFTP server on your machine and set the home directory to where you have downloaded the files. We will use the controller GUI to download the latest software on controller. Select Command>Download File option as shown in the screenshot below

IOS UpgradeIOS Upgrade ProgressIOS Upgrade Complete

Restart the WLC and then upgrade the Field Recovery Image

Field ServiceField Service Upgrade Complete

Restart again and on start up you will be asked to input your answer, you need to be very careful here, as if you loose power to device, it will be unrecoverable. These warning messages are displayed during the process. Also, there is timeout set and if you don't answer a question within certain time, it will abort the upgrade process.

Field Service Upgrade CLI Progress Warning

 

4. Once the upgrade process is complete, you can see the latest software version displayed on the monitor page. Lets move to the next part of initial configuration

All Upgrade Complete

 

5 . If you haven't already set you will set the name, RF Group Name, Default Mobility Domain Name.

6. Enable Network Support by using menu Wireless>802.11b/g/n>Network. It must be enabled otherwise radios on APs attached to controller will stay down.

Enable Network Support

 

The next post details setting up SSIDs, Configuring Interfaces, Configuring AP Groups and use FlexConnect for APs on remote sites.

http://www.xerunetworks.com/2012/05/cisco-5508-wlc-configuration-lab-wpa2-guest-access-flexconnect-aka-hreap/

Leave a Reply

%d bloggers like this: