Monthly Archive: May 2012

May 24

RSPAN Configuration for Cisco 6500 Switches

Depending on the IOS Version and platform, the Remote SPAN configuration can be a bit different. In this post I will be configuration RSPAN session between a Cisco 6506 switch running IOS Version 12.2(33)SXI and Cisco 6509 running IOS Version 12.2(17d)SXB1.





Source: Cisco 6506 (IOS Version 12.2(33)SXI)

1. Configure …

Continue reading »

May 23

Cisco 5508 WLC Configuration LAB – WPA2, Guest Access, FlexConnect (aka H-REAP)

This posts starts with setting up a LAB to configured and test WLC. The WLC will be setup with two SSIDs on local and remote site. The SSIDs will support WPA2 and Guest access with web authentication. Also, the remote site will support FlexConnect for one SSID which means traffic will not be transported back …

Continue reading »

May 22

Fedora ARM Image Installer–SD Card Selection

I was trying to follow this guide ( to put Fedora ARM image to my SD card which needs to be at least of 2GB capacity. However in image installer window I was not getting the exact option to selection SD as destination device for image. I was getting harddisk1 (8G) instead of anything …

Continue reading »

May 10

Cisco 5508 WLC Setup and Initial Configuration

This post details how to  do initial Cisco 5508 WLC setup and in the next post it goes into more detailed steps of configuring WLANs. Following are some pictures of the device and then we start with initial configuration and software upgrade




Cisco 5508 WLC …

Continue reading »

May 09

Cisco ASA 8.4 Migration – Test it first on GNS3

This post details how to test Cisco ASA 8.4 migration on GNS3 such that you know in advance how its going to effect your existing configuration(Pre 8.3).  To do this you will have to first follow the following post which will get you an ASA working and is connected to its host machine.

Continue reading »